White Natural BASELL EP332L PPCP Granuels

Product Description

Moplen EP332L is a heterophasic copolymer with medium flow used in injection molding. This grade is characterized by a medium stiffness-impact balance at low temperature as well as a low warpage tendency. The additive formulation provides a good heat aging resistance. Moplen EP332L is typically used by customers requiring a high resistance to temperature degradation, in particular for battery cases and automotive components.

This grade is not intended for medical and pharmaceutical applications.

Status Commercial: Active

Availability Africa-Middle East; Asia-Pacific; Australia and New Zealand; Europe; South & Central America

Application Battery Cases

Market Automotive; Consumer Products; Industrial, Building & Construction

Processing Method Injection Molding

Attribute Good Heat Aging Resistance; Good Impact Resistance; Good Stiffness; Heat

Stabilized; Impact Copolymer; Low Warpage

Health and Safety

The resin is manufactured to the highest standards, but special requirements apply to certain applications such as food end-use contact and direct medical use. For specific information on regulatory compliance contact you ocal representative.

Workers should be protected from the possibility of skin or eye contact with molten polymer. Safety glasses are suggested as a minimal precaution to prevent mechanical or thermal injury to the eyes.

Molten polymer may be degraded if it is exposed to air during any of the processing and off-line operations. The products of degradation may have an unpleasant odor. In higher concentrations they may cause irritation of the mucus membranes. Fabrication areas should be ventilated to carry away fumes or vapours. Legislation on the control of emissions and pollution prevention should be observed.